The water industry’s solution to event duration measurement in combined sewer overflows
Pulsar’s MicroFlow-i delivers accurate, repeatable velocity measurement for liquid flow, either as an individual sensor or by providing HART communication protocol or a 4-20mA loop powered signal into a SCADA system. Its lightweight, compact design makes installation simple, especially within confined spaces, and requires no interruption to normal operational flow.
Microflow-i options
The MicroFlow range has been specified and designed to meet the demanding requirements of today’s process flow measurement applications. The unit is positioned above and at 45 degrees to the flow and measures flow velocity. The standard RS485 version is Ex mb certified for use in Zones 1 and 2, and the 2 wire loop-powered version with HART protocol is intrinsically safe (Ex ia) for Zone 0.
Microflow-i communication
The 2-wire version can be used in digital HART mode or as a 4-20mA loop-powered device. The MicroFlow-i can be set up using a HART modem with either proprietary HART software such as PACTware, or MicroFlow HART PC software.
Cable lengths & brackets
Standard cable lengths 10 m (32.8 ft), 20 m (65.6 ft), and 30 m (98.4 ft) are available.
The MicroFlow-i should be installed directly above the flow with the axis at 45 degrees to the flow to be measured. We have a range of brackets available that will assist with installation angles.
The right meter for
- Event Duration Measurement
- Combined Sewer Overflows
- Open Channel Flow Monitoring
- Remote Locations
- Velocity Area Solutions